What is the most likely cause? Oil or grease on the friction surface(s) The starter motor spins but the engine does not crank. What is the most likely cause? The clutch pedal linkage needs lubrication A clutch chatters when it is engaged. Which is the least likely cause? Misadjusted clutch switch A loud squeak is heard every time the clutch pedal is depressed or released.
#Evom excess play in drivline manual
What is the most likely cause? Misadjusted clutch linkage An owner of a vehicle equipped with a manual transmission and a cable-operated clutch complained that the transmission is difficult to shift without grinding the gears. Which technician is correct? both A clutch engages close to the floor and will often not disengage. Technician B says the clutch may require replacement. Technician A says that the clutch linkage may need adjustment. Which technician is correct? both An owner of a manual transmission vehicle complained that the clutch slipped during hard acceleration. Technician B says the clutch master cylinder may be defective. Technician A says that the hydraulic clutch may need to be properly bled. Which technician is correct? tech b A clutch on a pickup truck equipped with a hydraulic clutch does not disengage. Technician B says that the bearing retainer should be replaced to provide the proper operation of the throw out (release) bearing. Technician A says that the front transmission bearing should be replaced. Which technician is correct? both A scored transmission input shaft bearing retainer (quill) was discovered when the transmission was removed to replace a worn and slipping clutch.
#Evom excess play in drivline install
Technician B says that it may be necessary to install a shim between the crankshaft and the flywheel if the flywheel is machined. Which technician is correct? tech a Technician A says that the flywheel should be resurfaced whenever the clutch friction disc and pressure plate are replaced. Technician B says that the cause may be due to a defective throw out (release) bearing. Technician A says that the clutch may be slipping. The owner of a manual-transmission vehicle stated that the transmission shifts normally but the engine speed does not drop after an upshift has been completed and the clutch has been released.
0 kommentar(er)
